Product

How to Restore Antique or Old Furniture

You can easily transform a piece of furniture cheaply by removing off the old paint and refinishing the wood as to its initial state. By stripping old furnishings down to the natural wood you can ensure a smooth surface – devoid of bumps and blemishes – which can be polished, varnished or perhaps stenciled for a complete makeover. Ensure very first that you know what finish you are stripping because, paint, polish, lacquer or varnish all need different treatments.

Devices: By hand, you require paint stripper, liquid or jelly form, methylated spirits, and turpentine. A set of rubber gloves, old paintbrush 25 – 50 mm wide, a scraper, coarse wire wool and sandpaper fine to medium grade.

Paint Stripping: if you are an expert for hard work it can be eliminated by immersing the short article in a caustic bath. A more secure suggestion I would advise by hand, utilizing a chemical paint stripper; this gives terrific results as it adds an extra appeal to the bare wood.

Method: Firstly make certain that your work area is well aerated as paint stripper produces undesirable fumes. Get rid of all fittings deals with, crucial guides, etc, then start brushing the stripper on to the painted areas, work the stripper into all cracks/crevices. When you have actually covered a workable area, leave the stripper to act for several minutes. When it begins to bubble, get rid of the paint layer with your removing knife or scraper, (put the paint shreds into an old paint tin as being caustic they threaten) repeat the procedure up until you reach the wood. When all the paint has been removed, the next action is to wash the wood down with the manufactures recommendation on what neutralizer to use this will get rid of any staying debris at the same time reduces the effects of the stripper. If the suggested neutralizer is said turpentine then soak a ball of wire wool and thoroughly rub-down the stripped surface. When dry sandpaper to a smooth surface. Crucial; always rub in the instructions of the grain.

Stripping polish: before you can get rid of successfully, you need to know first the type of polish. If it is French polish this can be removed quite easily with methylated spirits, wipe it on kindly, leave for a few minutes. When the polish has actually softened, scrape it off with a scraper then with great wire wool (taken in Methylated spirits) when the wood is dry you can sandpaper down to a nice smooth surface. If it is a Wax polish (oily surface area) this you can get rid of fine steel wool soaked with turpentine. Repeat up until you are at the bare wood, dry off with an absorbent cloth.

Varnished and Lacquered surfaces: if the article being 50 years or more old it most likely is an oil-based varnish of which was made from resins dissolved in oils and solvents. The cleanest/easiest way is with a scraper; tilt the scraper far from you working along the grain (never across the grain). Polyurethane varnishes use a paint stripper. Cellulose-based varnishes can be removed by paint stripper, acetone, cellulose slimmers, ammonia caustic soda, or turpentine. Recommend test a little area first to see which works finest. Repairs, now you have the ability to see the various faults. Your repairs are required prior to the new surface can be used, maybe the draws need re-nailing or weak joints to be glued, cracks and holes must be filled. Minor cracks and holes you utilize a plastic wood or non-shrinking stopper all available in various natural wood colors. Big holes must be Plugged with a comparable wood, cut to shape ensuring the grain of the pug runs the same way as the rest of the surface area, and then glue it in. Great sandpaper all your repairs down to a smooth surface for the next phase. Check more about tozsuz sistre cila.

Leave a Reply

Your email address will not be published. Required fields are marked *